As a special equipment for the floating fish feed production of extruded feed, the fish feed extruder will encounter some shortcomings more or less in use. Today, the reasons for not discharging or abnormal discharging will be analyzed, and corresponding solutions will be given.
The feed pellet extruder does not discharge. The main performance is that during normal production, or just starting up, there is no material at the main die head.
solutions of floating feed pellet extruder not discharge
①The particle size of the food extruder is coarse.
solution: Sabotage to Skill Request
②Turn on and add less water.
Solution: Add water to the skill request
③The main motor of the feed extruder is reversed.
Solution: change the phase sequence of the main motor incoming line
④There is residue in the barrel that has not been drained.
Solution: stop and clean up before production.
⑤ The temperature is not balanced.
solution: adjust the temperature according to the skill request
making fish feed ingredients
The feeding of the feed extruder is abnormal. The main performance is that the material is discharged too fast, and the puffing is excessive or not puffed.
①The moisture content of the material is low.
Solution: Add Moisture Content
②The temperature controller is out of control.
Solution: replace the temperature controller
③The screw of the feed extruder is worn.
Solution: replace with a new cut segment.
The reason for not puffing: the temperature is too low. Solution: Adjust by skill request.
The feed extruder does not cut the material normally. The main performance is that the product is not puffed and may have burrs.
Reason: The single tool space of the extruder is too large or worn. Solution: Adjust or replace from scratch.